killofactory.blogg.se

• #How to make applique using sewart how to#

If you wish to stitch around the edges of the applique, cut a piece of stabiliser about 1-2 inches wider all around than the applique, and position it on the wrong side of your fabric, underneath the applique.Ĩ. I recommend using a press cloth as it will help prevent scorching the applique and the fabric you’re fusing it to.ħ. Please refer to the instructions that come with your fusible webbing for more details. Note: Iron temperature and fusing time will depend of the type of fabric and fusible webbing you are using. When happy with the arrangement, place a press cloth over the design, then fuse in place with an iron.

Peel off paper backing, then position applique pieces on project (webbing side down), layering the pieces as indicated on the placement guide.Ħ. Tip: when cutting out small, fiddly pieces, hold the piece with tweezers instead of your fingers.ĥ.

Cut out applique piece(s) neatly on the lines. Place the fusible webbing piece(s) onto the wrong side of chosen fabric, then fuse for a few seconds with a dry iron.Ĥ. Cut out the piece(s) roughly leaving about 1/4 inch of webbing around the tracing lines.ģ. Trace the applique design piece(s) from the template onto the paper side of fusible webbing, leaving about ½ inch between each piece.Ģ.

#How to make applique using sewart how to#

This step by step guide will show you how to make appliques by hand, how to apply them to your project, and how to sew the appliques using a regular sewing machine.ġ.